The outstanding features of "SANGUAN" 100 system heat insulation high airtight type floor spring door are
First, all the aluminum profiles of frame and fan of this system are heat insulation profiles made of two aluminum profiles compounded by nylon heat insulation strips, which not only have good heat insulation, but also can make the door into different colors inside and outside according to the requirements of the decorative effect of the door surface, which is beautiful and generous.
Second, this system can meet the double and single spring doors with brightness and side brightness, and the series of partition and kitchen window with heat insulation should be * among the profiles.
Third, the system has EPDM rubber sealing strips around the opening fan to keep the ring seal, with high air and water tight performance.
Fourth, this system is equipped with round, square corner, lace and slope pressure line of various widths, the large inlay glass slot can reach 36 mm, all pressure lines are common in the fixed part and the opening fan.
Fifth, the system is equipped with a mid-waist profile, which can be used to make two pieces of glass above and below or decorative panels below the glass, and can be used to make the lower kick below the door at any splicing height.
Sixth, the system is equipped with combined sewa-shaped glass pads, which can squeeze the edge of the inlaid glass and the bottom gap of the embedded glass to prevent the door from falling off the corner of the deformation caused by the sinking of the large size door.
